What should I pay attention to when using the saw guide bar

　　What should I pay attention to when using the saw guide bar? How to make effective use?

　　When the chainsaw guide bar is in use, most people may not know how to use it effectively. At present, there are many precautions in the use of the current chainsaw guide bar.

　　First, filter out the debris

　　When the chainsaw guide bar is in use, although the requirements for lubricating oil between the chain and the chain are not particularly high, usually the waste oil from the engine can also be used. Be sure to filter all the oil and related debris before used to avoid clogging.

　　Second, don’t adjust too tightly or too loosely

　　When using the chainsaw guide bar, you must pay attention to the relevant installation. After installation, the entire chain needs to be close to the guide bar. Use a screwdriver to push and pull all the chains forward. In this case, you can push freely and install all the chains. You can then pull the entire chain away from the guide bar. In this way, almost half of the guide sprocket can be pulled up.

　　Third, buy qualified guides

　　When using the chainsaw guide, you must purchase qualified products, because these products are of better quality and harder in texture. The product must be flat during use, and there can be no bending.

　　What should I pay attention to when using the saw guide board? All the above conditions should be paid attention to, and you must be particularly aware of them during use.